Hi, i’m putting together a John Lewis corner unit, (tvilum-scanbirk 65010) and 8 of the drill holes are too small to take the screws that are provided. All of the other pieces are matched up and accounted for so the only option I can see is to make the holes wider myself using a drill. Or could the instructions be wrong? Either way its not something I really want to have to do - any advice gratefully accepted.
Thanks

Hi Phil,

I have never come across this type of problem with John Lewis furniture.

You have probably used the wrong screws elsewhere and therefore are left with screws that are too big for these holes. I would double check the quantities used in early steps against the inventory to see where you have done it. The screws you could have misused might not be holding other parts correctly so double check.

You can drill the holes wider if you are carefuly but this shouldn’t necessary and I am sure you have made a mistake earleir in yur assembly.

Edwin.